American Mineralogist· 2012Q1
Manganatlarda Mn Valans Durumlarının XANES Spektroskopisi ile Belirlenmesi
Determination of Mn valence states in mixed-valent manganates by XANES spectroscopy
- 343atıf
- Q1SCImago
- 2012yıl
Kısa özet
Manganatların Mn K-ucu XANES spektrumlarının bir derlemesi, doğrusal kombinasyon uyum analizi kullanılarak karışık valanslı bileşiklerdeki Mn valans durumlarının (Mn2+, Mn3+, Mn4+) belirlenmesi için bir veritabanı sunmaktadır.
Yapay zekâ ile başlık ve abstract'tan üretildi; tam metin okunmaz.
Ana noktalar
- Valans durumu belirlemesi için manganatların Mn K-ucu XANES spektrumlarından oluşan bir veritabanı derlenmiştir.
- Referans spektrumlarının doğrusal kombinasyon uyumunu kullanan 'Combo yöntemi', Mn2+, Mn3+ ve Mn4+ fraksiyonlarını nicel olarak belirler.
- Ortalama valans belirleme doğruluğu, Mn3+-Mn4+ aralıkları için 0.04 v.u. olarak tahmin edilmektedir.
- %15'ten fazla Mn2+ varlığında veya Mn3+ Jahn-Teller bozulmaları nedeniyle phyllomanganatlarda doğruluk azalır.
Yapay zekâ ile başlık ve abstract'tan üretildi; tam metin okunmaz.
Özet (abstract)
The valence states of Mn in mixed-valent layer and tunnel structure manganese dioxides (MnO2), usually referred to as phyllomanganates and tectomanganates, can be measured by X-ray absorption near-edge structure (XANES) spectroscopy with a precision and accuracy that are difficult to estimate owing to the paucity of well-characterized standards. A compilation of the Mn K-edge XANES spectra of most naturally occurring manganates, synthetic analogs of known structure and chemical composition, and pure-valence phase species is presented and made available as an open source. We intend this compilation to serve as a basis for the spectroscopic determination of the fractions of the Mn 2+, 3+, and 4+ valences in mixed-valent manganates and phase mixtures. The XANES derivatives of tectomanganates and phyllomanganates with no or little Mn3+ in the MnO2 layer exhibit intensities, shapes, and relative energy positions of the main features characteristics of a particular valence composition. For these compounds, valence fractions can be derived using linear combination fitting analysis. Best quantitative results are obtained when the unknown spectrum is fit to a weighted sum of all reference spectra in the database with the fractions of species constrained to be non-negative (Combo method). The accuracy of the average valence is estimated to 0.04 v.u. in the range of 3+ to 4+, and decreases when the proportion of divalent Mn is higher than 15%. The accuracy of the method is also lower in (layer Mn3+, Mn4+) manganates, because the XANES features are affected non-additively by the amount and distribution of the Jahn-Teller Mn3+ cations. The merit of the Combo method for the determination of manganese valence sums relative to the methods based on calibration curves is discussed.
Yazarların özeti; kaynağından alınmıştır. American Mineralogist, 2012 · DOI ↗
Ücretsiz hesapla devam et
Makaleye Sor ile bu makaleye günde 3 soru ücretsiz; makaleyi kaydet, kaynakçasını al, ilgi alanına göre her gün yeni özetler. Çıkarımlar Premium.
Web'de ücretsiz devam etGoogle ya da Apple hesabınla giriş; kart istemez. Bu makaleye geri dönersin.
Telefonda:
Alan: Elektrokimya
ElectrochemistryChemistry